Supalight versions are also available for some applications which offer a further reduction in weight and inertia. TTV lightweight billet steel flywheels are available to suit standard style clutches or race / rally type clutches in 140mm (5 1/2") 184mm (7 1/4") and 200mm diameters. Available so suit standard type clutches as well as race / rally type clutches.Improved engine braking and gear changes.Lighter weight reduces inertia for better engine response and acceleration.Strong billet steel construction capable of withstanding very high Rpm's.The result of this is instant throttle response, better acceleration, quicker gear changes and increased engine braking. The lightweight construction offers a much lower inertia which gives more available power at the driven wheels. Although lighter than the original flywheel, the TTV flywheels retain the same depth for the clutch area giving strength and reliability. Mass on S54 cars and its just nasty resonances and vibration at lowĮngine speed when on low gear.TTV lightweight flywheels are machined from billet steel and feature an integral ring gear. I see not much gains for having SMF vs DMF I have installed a single Under load but still the lash goes thru harmonics in different loads Lash chatter for the worst transferring the vibrations to the crankshaft.Īt hi engine speed the gear box lash gets much less because all is S54 has Nasty harmonics and having SMF is only making the gear The tranny is very quite with the DMF even driven straight for an hour I said this is bad transmission.but ones the issues I had was fixed G420 on idle was going lose its own guts on the ground !!! to a point Was extreme lumpy like the engine did not have vanos. Synchro to stick when shifting and will cause hard shifting.ĭuring tune on the E24S54 I had some issues with ITBs and the idle MT90 is not good for cold climates because it will cause the 3 piece I have tested and it works very very well straight MT-90 This trick can be done on G420 but for those who are in The trick is to mix MT90 with MTLĥ0-50 so that to cushion the gear chatter which is caused by the worn Part on the car and they get little chatter at idle but that can be seen onĬars whit over 100k and poorly maintained. This item is made in the United Kingdom Get crisp engine response Lightweight flywheel for BMW E46 M3 Engine code : S54B32 Made from forged chromoly steel Weight: 5. Quite but as the milage increase the gears do ware out as any other TTV Racing 549.99 Add to Cart 5 in stock Dispatched today Order within 13 h and 53 min. That only increases chatter and yet these transmission are very very I have almost zero chatter at +/-750rpm idle speed.Į34M5 does not have a Vanos system and the idle is extreme lumpy and On one of my DD E24M6 I haveħ.4 pounds fly wheel and 228mm set up. When these transmission were under 100k miles with Older E28M5, E34M5 3.5 came from the Factory with SMF. G420 design does not have internal Damper Springs to reduce chatterīecause the G420 was design for cars with Dual Mass fly and the DMF One must understand the design of the transmission. You must contact them to order as it's not listed online.Īs mentioned by others, the idle chatter is caused by the transmission and is unavoidable when using a SMF regardless of brand.BBR, They're made to order and very high quality (used in many Porsche race cars as well) and last time I checked are under $400 and made in USA. FWIW, AASCO makes an E46 M3 flywheel which is 11lb (this one here is 5.3kg/11.7lb) and can be reduced to 10.5lb upon request.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |